Electrostatic discharge simulator that complies with the EN/IEC61000-4-2 standard
Maximum testing voltage of ±30 kV exceeds all prescribed test levels
Support of ISO 10605 standard (*1)
Tip charge prevention feature

Full compliance with ISO 7637-2 2004
Load dump suppressor for pulse 5b
Built-in CDN* for high waveform reproducibility
Compact modular cabinet
Communication control lines separated from output lines for secure operation
Two types of CDNs available (60 V/10 A and 60 V/50 A)
Output terminals provided at a height of 5 cm above the floor level as specified in the ISO 7637-2 standard (enhanced reproducibility)
Dedicated software for condition setting and tester control
JASO D001-94 unit offered as an optional module

Bipolar power supply supporting a maximum range of ±60 V at ±50 A (Four models are available with power capacities of 12.5, 25.0, 37.5, and 50.0 A, respectively.)
The frequency response is 100 kHz (full voltage swing of ±60 V, no load) and the internal impedance response is 10 m ohm or less*
Rise/fall time: 1μs min. (square wave, full voltage swing of (60 V, no load)
The main unit of the power supply contains an arbitrary pulse generator.
Synchronous output tests can be conducted on up to four channels.
The tester is capable of catering to individual auto makers' test requirements (except for extremely rare ones).
The tester can have a switch module built in it (factory option).

Up to 50 test conditions can be registered in a test execution list, and tests are carried out in accordance with the list.
For transient surge testing, up to seven types of pulse modules can be controlled.
For supply voltage variations testing, up to four testers can be controlled for synchronous operation by communicating with a single tester.
In addition to those compliant with the ISO 7637-2 2004 standard, a variety of waveforms can be generated easily (for supply voltage variations testing).
The created test execution list can be saved in a file along with comments.
The result of the OK/NG judgment that the user makes at the end of each test can be saved in the execution list.
The RS-232C interface is supported for communication.