Frequency range from 1mHz to 30MHz
SG?4211 : 1mHz to 20MHz
Sync output
Maximum output amplitude: 16Vp-p（at 50 ohm load), 32Vp-p（at the open end）
Big LCD screen with back-lighting
Variable delay in TRIG, GATE and EXT BUR modes （SG-4311）
Full remote control via GP-IB interface
High-quality output waveforms
Variable duty cycle
Comprehensive modulation
Various operation modes
Output hold function

Employing high frequency stability and low distortion DDS
Easy operation
10ppm (SG-4115), 50ppm (SG-4105) frequency stability
2 channel outputs and arbitrary waveform function
Chassis and signal ground are isolated up to 42Vp-p.
AM, FM, PM, FSK, PSK, PWM modulations are available. (SG-4115)
Both GP-IB and RS-232 come with as standard.
Output 50mVp-p to 10Vp-p (100mVp-p to 20Vp-p output open), Offset voltage range +10V to -10V (output open)
Linear / Log SWEEP, BURST, DUTY control function
Useful CH COPY function (SG-4115)

Accuracy : +-2% or less of set value
Oscillation frequency display of 3-1/2 digits using large LEDs
Wide oscillation range from 0.1Hz to 1MHz
Simultaneous 50 ohm and 600 ohm outputs
Pulse generation with variable duty ratio
Fast 50ns square wave rise/fall time
Max. 20Vp-p high output voltage (with terminals open)
TTL-level synchronized output
Compact, lightweight and portable

6 waveform outputs are obtainable -sine, triangle, square (50:50), square (variable), DC, and AM
Frequency range is continuously variable between 0.1Hz to 10MHz
VCF (Voltage Controlled Frequency) and VCA (Voltage Controlled Amplitude) are provided
Variable duty ratio up to 85:15 permits use as a pulse generator
Simplified panel design

Deflection factor and attenuator compensation (maxu/imum output voltage : 100V, square-wave : 1kHz)
Sweep rate (high accuracy by using a highly stable crystal oscillator)
Pulse response (fault- and distortion-free square-wave output)
Leading edge of square wave (rise time : 100ps or less)
Trigger checking